Metallurgical Industry

Water filtration in the metallurgical industry is a critical issue, as it must ensure the quality of production processes and protect the surrounding environment. This industry uses large quantities of water in various stages of the metal production and processing cycle, including cooling, cleaning, and transport.

SATI filters are widely used in this industry to ensure the quality of the water used. These filters are designed to address the specific challenges of this industry, where water can be contaminated by a variety of impurities, including oils, fats, sediments, and heavy metals.

In metallurgical processes, it is common for water to contain oils and greases from lubrication and cooling operations. SATI filters are designed to effectively remove these substances, ensuring that the water is clean and free of contaminants before being reused in industrial processes.

Another key role of SATI filtration systems is the removal of sediment from water, which can cause blockages and damage production equipment in the metallurgical industry. SATI filters use advanced technologies to capture and remove sediment, ensuring a constant water flow and preventing damage to machinery and facilities.

Furthermore, water recovery in the metallurgical sector through the use of SATI filtration systems is also a key practice for ensuring operational efficiency and environmental sustainability. These systems offer advanced solutions for treating process water and enable its reuse, thereby reducing water consumption and minimizing the environmental impact of metallurgical activities.

Reusing treated water reduces dependence on drinking water and natural water supplies from the public water system, contributing to water conservation and environmental sustainability. Furthermore, by treating and recycling process water, the discharge of wastewater into the environment is reduced, thereby minimizing pollution of surface and groundwater.

In conclusion, SATI filters are a reliable choice for water filtration in the metallurgical sector, offering tailored solutions to meet the specific needs of this industry and helping to improve operational efficiency and environmental sustainability in the metallurgical manufacturing sector.

Our Filters

All filters can be customized to meet the customer's needs.
We also design custom filtration systems.

Case Studies

Water plays a crucial role in the metallurgical sector for metal production and processing, but it is also subject to environmental and quality risks. Therefore, the adoption of effective water management and treatment solutions is essential to ensure the sustainability of metallurgical operations and the protection of the surrounding environment.

Furthermore, in the metallurgical sector, it is essential to implement wastewater management practices to properly treat and dispose of wastewater, thereby minimizing pollution of surface and groundwater.

Location
Egypt
Filtration grade
5 µm
Flow rate
240 m³/h
Treated water
Process water
Industrial Steel
environmentally friendly

One of the largest steel producers in Egypt and the Middle East, which manufactures over 2 million tons of steel products annually, uses a considerable amount of water in its production process; once used, this water is discharged.

The company’s goal was to recover more than 70% of the water normally discharged from the production process. This goal was achieved through the use of Vortex filters, Rotor filters, sand filters, Big Matic filters, and, finally, a reverse osmosis (RO) system. The objective of the filtration system was to ensure a total suspended solids (TSS) content of less than 5 mg/l, starting from a TSS content of approximately 50 mg/l.

Wastewater from the plant’s various sources is collected in an equalization tank and then pressurized to feed a system consisting of three Vortex filters. The water, after being filtered to remove coarse particles, then enters a filtration system consisting of three Rotor filters, with a filtration rating of 50 microns.

The water is then filtered through six sand filters. The final microfiltration is performed by a set of Big Matic filters, with a filtration rating of 5 microns.

The PDF for this case study
is available only to registered users of the site.

Contact us

HEADQUARTERS

116 Via M. Galli
47522 Cesena (FC) – Italy

CALL US

Tel. +39 0547 660307

CONTACT US
SOCIAL

    Company certified to UNI EN ISO 9001:2015

    sati_img_certifications